“journalctl -f -u rvice” stops at “(MainThread) Update PulseAudio information” which doesn’t tell me anything. I attached the left (DATA)-leg to GPIO 23, the middle leg to GND and the right leg (Vs) to +3.3V. Socat and Node-RED were installed (each are optional). The kiosk/dashboard environment was set up. The kiosk/dashboard environment was set up. This is a continuation of Part 1, in which: A new lite Raspberry Pi OS image was installed and configured. I was able to successfully run the following:Īpt-get install -y software-properties-common apparmor-utils apt-transport-https avahi-daemon ca-certificates curl dbus jq network-manager socat This is a continuation of Part 1, in which: A new lite Raspberry Pi OS image was installed and configured. “sudo add-apt-repository universe” which failed but as I’m running Raspbian and not Ubuntu I figured that might be alright. The pi OS is a fresh Raspbian lite install.Īs far as my installation goes I’ve follow these steps: I’m trying to install hassio using the "Alternative: install Home Assistant Supervised on a generic Linux host, " on a raspberry pi 2 but so far I’ve been unable to reach the hassio landing page (in my case 192.168.2.30:8123).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |